Hardware Manual

www.acti.com

Hardware Manual

Indoor Installation Procedures

This section describes the procedures in installing the camera indoors using PMAX-1104 indoor

bracket (purchased separately).

When using brackets from other manufacturers, check the installation guide included in the

bracket to install the camera. Similar procedures apply when using brackets from other camera

manufacturers.

NOTE: Some pictures in this documentation only show one type of camera lens; this means that

the procedures are applicable to other types of lens, unless specified otherwise.

Step 1: Attach the Camera Lens

NOTE: To avoid scratches or leaving fingerprints on the lens, it is recommended to retain the

protective cap covering the lens until the camera is completely installed.

1. Unpack the camera and check the bundled camera lens. The camera comes with one of the

following lens.

D21FA / E21FA

D22FA / E22FA / E270

D2xVA / E2xVA / E2xA /

E23B / E271

2. Pull to remove the cap covering the camera lens holder.