User manual

2.16.3 Mounting to a Concrete or Brick Wall

Use the supplied materials and suitable tools for mounting the camera to a con-

crete or brick wall. Follow the

Mounting Instructions

below to complete the installa-

tion.

Required Materials:

• 3 hex head screws (Pos.17)

• 3 washers (Pos.16)

• 3 dowels (Pos.15)

Required Tools:

• Power drill

• Suitable drill bit

• Wrench or ratchet for M6 hex heads

• Hammer (optional)

• Allen wrench 5mm (item3)

Mounting Instructions:

• Hold the drilling template at the position where you would like to mount the

camera.

• Mark the holes for drilling with a pencil or a sharp object, then remove the

drilling template.

• Drill the holes with the power drill where you just marked.

• Insert a dowel into each of the holes you just drilled. If required, use the

hammer to press the dowels into the holes.

• Slide a washer (item5) over every hex head screw (item6).

• Hold the camera against the wall. Make sure that the openings in the

mount's foot line up with the dowels.

• Insert the four screws (with washers) into the openings in the foot of the

camera and into the dowels.

• Tighten the screws using the wrench or ratchet (max. torque is 4Nm/

2.95lbfft).

www.mobotix.com • sales@mobotix.com

78/124

D12 Camera Manual Part 1

Find the drilling template

at the end of the manual

Max. torque for all

screws: 4Nm

(2.95lbf ft)