User manual

2.15 Mounting the Camera
• Copy or print the drilling template for the SecureFlex mount at the back of
the manual (make sure
not to scale the template).
• Mark the holes; when using a wall outlet, make sure that the outlet lines up
with the upper rim of the mount so that the cable is not bent too sharply later
on.
• Drill the holes and insert the supplied dowels (this is usually not necessary
for a wooden wall or structure that is thick enough). Make sure to follow the
instructions in section 2.14,
Mounting the Camera to Different Surfaces .
• Connect the cables (see section 2.12,
Preparing the Installation ).
• Properly fasten the SecureFlex mount using the supplied screws and the ap-
propriate washers to the wall. Make sure to follow the instructions in section
2.14,
Mounting the Camera to Different Surfaces .
• Establish a connection from your computer to the camera (see chapter 3,
Operating the Camera ) and adjust the camera position according to the live
image delivered by the camera.
• Properly tighten the screws of the mount itself and make sure that all screws
are properly fastened, then press the supplied caps onto the heads of the
hex screws.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
74/124
D12 Camera Manual Part 1
Max. torque for all Allen
screws: 4Nm
(2.95lbf ft)
Find the folded drilling
template at the end of
the manual!
All measurements in mm!
Caution
Never use screws with countersunk heads to fasten the mount, as
these screws will destroy the mount.