User manual

2.12.4 Mounting the Camera on the Bottom Plate

In order to mount the camera to the bottom plate, use three of the supplied Allen

screws M4x25mm (item21), three washers Ø 4,3mm (item22) and the corre-

sponding hex nuts.

•Guide the connector cables of the camera from below (smooth side)

through the round opening of the bottom plate (item14).

• Position the camera on the underside of the bottom plate so that the PIR sen-

sor points in the desired direction and the hole in the housing to the right of

the PIR sensor is situated above a hole in the bottom plate.

• Insert the first M4 hex nut (item20) into the corresponding hole of the bot-

tom plate, then use one Allen screw M4x25mm (item21) and a washer Ø

4.3mm (item22) and

lightly

fasten the screw.

• Turn the bottom plate around and determine the number next to the hex nut

you just inserted (example: PIR points

straight ahead  hole should have

the number1). Insert the remaining

M4 hex nuts (item20) into the other

holes with the same number (1 in this

case) and use the two Allen screws

M4x25mm (item21) with the corre-

sponding washers to mount the cam-

era to the bottom plate.

www.mobotix.com • sales@mobotix.com

66/124

D12 Camera Manual Part 1

Mount the camera housing

to the bottom plate

be-

fore

mounting the bottom

plate itself

PIR sensor of the camera

looks straight ahead:

Position 1

Caution

When fastening the Allen screws using the 3mm Allen wrench,

make sure that you do not scratch the camera dome!