User manual

Use the supplied drilling template (at the end of this manual) to mark the position

for drilling the dowel holes and the holes through which the cables will be led later

on. When printing or copying the drilling template, make sure that it is not scaled

down!

• Use the supplied 10mm dowels (item15),

8x70mm screws (item17) and 9mm dia.

washers (item16) for mounting the Outdoor

Wall Mount to the wall!

• Before mounting the wall mount, attach the

supplied wall sealing (item18) to its rear

(wall) side using some silicone sealant. If the

outdoor wall mount is mounted to a very

rough surface, the top of the wall mount

should also be sealed against the wall using

good-quality silicone sealant.

• The rectangular opening at the wall mount's

rear side is supposed to cover the wall outlet.

• If you

do not

use the pre-installed Ethernet

cable, make sure that the cable runs at

least 70cm (28in) from the wall or wall out-

let (80cm (32in) when using the Corner and

Pole Mount, see section 2.11).

www.mobotix.com • sales@mobotix.com

64/124

D12 Camera Manual Part 1

Find the folded drilling

templates at the end of

the manual!

Make sure that the drill-

ing template is not scaled

down when printing!

Apply silicone sealant!

Cable length from wall:

min. 70cm (28in), min.

80cm (32in) when using

the Corner and Pole Mount

70cm/28in