User Guide

ACTsmart Operating and Installation Manual Rev. 1.2
14
Step Present Operation
1 Programming Card Add Card Batch. The Batch size is restricted to 50 cards.
2 Present Card First card in Batch
3 Present Card Last Card in Batch
from the mounting plate or the surface mount collar). Within 10 seconds of power up carry
out the following actions.
2. Present the card to the reader.
3. Take the card away from the reader for 1 second (more than 20 cm)
4. Within a further 10 seconds replace LK1. The reader will beep.
The card is now set as the Programming card. (Note: ACT recommends using an ACTsmart PIN and
Prox device if a network is required).
Adding a Card Batch to the Network:
Step Present Operation
1 Programming Card
2 Programming Card Delete Card Batch
3 Present Card First card in Batch to delete
4 Present Card Last Card in Batch to delete
Deleting Batch Cards to the Network:
Deleting Individual Card (Require Card Above):
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card
4 Programming Card Wait for 4 seconds, Buzzer sounds indicating timing... wait
required period.
5 Programming Card Buzzer stops - timer set.
Programming the Door Relay Time:
Default ACTsmart:
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card Delete Individual Card
4 Present Card Card above the card that needs to be deleted e.g. if card number
99 needs to be deleted, present card number 100
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card
4 Programming Card
5 Programming Card Buzzer sounds intermittently and the LED flashes RED to warn
you are about to default the system
6 Present Card Default ACTsmarts. Note: This deletes the Programming Card.
(Not Programming Card)