User Guide

ManualsBrandsACT ManualsOtherACTSMART

ACTsmart Operating and Installation Manual Rev. 1.2

Find Door Number:

Step Keypad Entry Operation

1 61 Find Door Numbers

2 1-8 Enter the door number to be found. The ACTsmart assigned the door

number starts to beep.

3 Press a key or present To stop the ACTsmart beeping.

a card

Find All Door Numbers:

Step Keypad Entry Operation

1 62 Find Door Numbers

2 Press

✔

Each ACTsmart beeps their door number

3 Press key or present card To stop the ACTsmart Beeping

at each ACTsmart

Adding a Slave to the Network

Another Slave can be added to the network by defaulting it first (see below) and then assigning it a

door number from the Master.

Removing a Slave from the Network

To remove a Slave unit from the network, simply disconnect it from the network.

Replacing a Slave Unit

To replace a Slave Unit, remove the old Slave from the network. Default the new Slave and add it to

the network. Assign a door number to it from the Master.

Replacing the Master Unit

If the Master Unit needs to be replaced, then replace it with a Slave unit already on the system, (as

it will have all the card/PIN information), and make it the Master. Add a new, defaulted Slave to the

network in place of the swapped-out Slave. Then assign a Door numbers to the new Slave - make sure

it is the Door number of the old Slave.

Restoring Factory Defaults

Enter Programming code followed by 80 followed by

✔

. If this is done on the Master ACTsmart then

all ACTsmarts on the network are defaulted (including the Master). If it is done on a Slave then only

the Slave is defaulted.

If the programming code has been forgotten, power up with the tamper open (by removing the main

unit from the mounting plate or the surface mount collar), while holding down the

✘

key. Release the

✘

key and then enter the default Programming Code (9999).

Defaulting memory takes 3-4 seconds. During this time, the buzzer will sound an elongated tone.

Programming ACTsmart Prox Only

To program an ACTsmart Prox Only device, a Programming Card must be assigned to the ACTsmart.

The Programming Card may be any ACTsmart HID card. This card may not be used to gain access.

If you have received a batch of cards, it is recommended to use the first (lowest numbered) card in

the batch as the Programming Card. To set the Programming Card into the ACTsmart Prox do the

following:

1. Power up the device with LK1 removed and the tamper open (by removing the main unit