User Guide

ACTSmart2 Operating and Installation Manual Rev. 1.1
19
Programming ACTSmart Prox Only (1070)
To program an ACTSmart Prox Only device, a Programming Card must be assigned to the
ACTSmart. The Programming Card may be any proximity card. If you have received a batch of
cards, use the first (lowest numbered) card in the batch as the Programming Card. To set the
Programming Card into the ACTSmart Prox do the following:
1. Power up the device with the tamper open (by removing the main unit from the mounting plate
or the surface mount collar),
2. Present the card to the reader. The reader will beep.
3. Take the card away from the reader for 1 second (more than 20 cm)
4. Present the card to the reader again. The reader will beep.
5. The card is now set as the Programming card.
(Note: ACT recommends using an ACTSmart PIN and Prox device if a network is required).
In the steps below, after a card is presented to the reader it must be taken away from the reader (more
than 20cm) for 1 second before presenting the card again.
Step Present Operation
1 Programming Card Add Card Batch
2 Present Card First card in Batch
3 Present Card First card in Batch
Adding a Card Batch to the Network:
Step Present Operation
1 Programming Card
2 Programming Card Delete Card Batch
3 Present Card First card in Batch to delete
4 Present Card First card in Batch to delete
Deleting Batch Cards to the Network
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card Delete Individual Card
4 Present Card Card above the card that needs to be deleted e.g. if card number
99 needs to be deleted, present card number 100
Deleting Individual Card (Require Card Above):
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card
4 Programming Card Wait for 4 seconds, Buzzer sounds indicating timing... wait
required period.
5 Programming Card Buzzer stops - timer set.
Programming the Door Relay Time: