User Guide

ACTSmart2 Operating and Installation Manual Rev. 1.1

User Arm Function:

Users with this function may arm or disarm the door after a vaild card or PIN is presented. Remember

the Arming Door option must be set on the Smart2 (Option 42). While the door is armed, the door is

locked and access is denied to other users until the door is disarmed. The red LED flashes to indicate

the door is armed. An auxilliary output may be switched to signal the state of the door. This output may

be used to arm/disarm an alarm panel. The output may be programmed to pulse instead of toggle (Option

43). To arm or disarm the door, press the

✔

key followed by the PIN code or valid card. An output from

the panel may be connected to the ACTSmart2 to indicate that the panel is armed. Check the Alarm Panel

Wiring diagram at the end of the manual.

To program a card or PIN with the arm function, program as normal, but press 9 before the

✔

key. See

the two examples below:

Step Keypad Entry Operation

110 Add Card Batch

2 Present Card First Card in Batch (lowest number card)

3 Present Card Last Card in Batch (highest number card)

49 Enable Arming mode (make sure Option 42 is set)

5 1-8, (optional)* Select each door this batch is valid for

6 Press

✔

End

Adding a Card Batch with Arming Function:

Step Keypad Entry Operation

112 Add PINs (Make sure Option 40 is set on PIN and Prox Units)

2 0001-9999 4-6 digit PIN code

39 Enable Arming mode (make sure Option 42 is set)

4 1-8, (optional)* Select each door this PIN is valid for

5 Press

✔

End

Adding a PIN Code with Toggle mode:

To summarise, the following steps are required for setting up tokens to arm and disarm alarm panels:

1. Program the ACTSmart2 to be an Arming Door - Option 42 On

2. Assign a card or PIN with the Arming function - see above.

3. Assign an Aux I/O as the Door Armed output - I/O Function Code 14

4. If required, turn the Pulse Door Armed Option on - Option 43 On

5. If required, assign an input as the Panel Armed input. This input verifies when the alarm panel is

actually armed. - I/O Function Code 15

6. Connect up according to the Alarm Panel wiring diagram.