User Guide

ACTPro IOM ver 1.0

Configuration

All IOM Input/Output Module configurations are performed via ACTWinPro.

Step 1.

The IOM configuration is available from the Database drop-down menu.

Click on the New icon to generate a new IOM input/output module in the

database.

Give the IOM a name and assign it a controller and the local I/O number. This

number must be the same as the dipswitch setting on the IOM. Remember to tick the

Enabled box. Finally, click the Accept icon

Step 2.

The inputs section of the screen allows each input to be assigned its own name. This

is the name that will appear in the log when the input changes state.

Inputs can be enabled by timezone and when an output is on. While the input is

enabled, it can be logged (if the Log tick box is checked) or it can generate an Alarm

when it goes active.