Technical data

Maintenance, troubleshooting, spare parts and dismantling
ACT 600 – 5000 39 – EN
8.4 Maintenance operation on the refrigeration circuit
Maintenance and service on refrigerating systems must be carried out only by certified refrigerating
engineers only, according to local rules.
All the refrigerant of the system must be recovered for its recycling, reclamation or destruction.
Do not dispose the refrigerant fluid in the environment.
This dryer comes ready to operate and filled with R407C type refrigerant fluid.
In case of refrigerant leak contact a certified refrigerating engineer. Room is to be aired before any
intervention.
If is required to re-fill the refrigerating circuit, contact a certified refrigerating engineers.
Refer to the dryer nameplate for refrigerant type and quantity.
Characteristics of refrigerants used:
Refrigerant Chemical formula TLV GWP
R407C - HFC
R32/125/134a (23/25/52)
CHF2CF3/CH2F2/CH2FCF3
1000 ppm 1653
8.5 Dismantling of the dryer
If the dryer is to be dismantled, it has to be split into homogeneous groups of materials.
Part Material
Refrigerant fluid R407C, Oil
Canopy and Supports Carbon steel, Epoxy paint
Refrigerating compressor Steel, Copper, Aluminium, Oil
Alu-Dry Module Aluminium
Condenser Unit Aluminium, Copper, Carbon steel
Pipe Copper
Fan Aluminium, Copper, Steel
Valve Brass, Steel
Electronic Level Drain PVC, Aluminium, Steel
Insulation Material Synthetic rubber without CFC, Polystyrene, Polyurethane
Electric cable Copper, PVC
Electric Parts PVC, Copper, Brass
We recommend to comply with the safety rules in force for the disposal of each type of material.
Refrigerant contains droplets of lubrication oil released by the refrigerating compressor.
Do not dispose this fluid in the environment. Is has to be discharged from the dryer with a suitable
device and then delivered to a collection centre where it will be processed to make it reusable.