Technical data

ACT 600 – 5000 3 – EN
Contents
1 Identification plate 5
2 Warranty conditions 5
3 Safety rules 6
3.1 Definition of the conventional signs used in this manual 6
3.2 Warnings 7
3.3 Proper use of the dryer 7
3.4 Instructions for the use of pressure equipment according to PED directive 97/23/EC 8
4 Installation 8
4.1 Transport 8
4.2 Storage 8
4.3 Installation site 9
4.4 Installation layout 10
4.5 Correction factors 11
4.6 Connection to the compressed air system 12
4.7 Connection to the cooling water network (Water-Cooled) 12
4.8 Electrical connections 13
4.9 Condensate drain 14
5 Start-up 14
5.1 Preliminary operation 14
5.2 First start-up 15
5.3 Start-up and shut down 16
6
 Technical data 17
6.1 Technical data ACT 600 – 5000 3/460/60 17
6.2 Technical data ACT 600 – 5000 3/575/60 18
7 Technical description 19
7.1 Control panel 19
7.2 Operation 19
7.3 Flow diagram (Air-Cooled) 20
7.4 Flow diagram (Water-Cooled) 20
7.5 Refrigerating compressor 21
7.6 Condenser (Air-Cooled) 21
7.7 Condenser (Water-Cooled) 21
7.8 Condenser water regulating valve (Water-Cooled) 21
7.9 Filter dryer 21
7.10 Capillary tube 22
7.11 Alu-Dry module 22
7.12 Hot gas by-pass valve 22
7.13 Refrigerant pressure switches LPS – HPS 23
7.14 Compressor crankcase heater 23
7.15 Electronic instrument DMC24 24
7.15.1 How to switch on the dryer 25
7.15.2 How to switch off the dryer 25
7.15.3 How to display the operating parameters – INFO Menu 25
7.15.4 How a service warning is displayed 26
7.15.5 How an alarm is displayed 27

7.15.6 How to show the alarm memory – LOG Menu 28
7.15.7 How to control dryer with remote control 28
7.15.8 Operation of the failure / alarm dry contact (potential free) 28
7.15.9 Connection to serial line 28
7.15.10 How to change operating parameters – SETUP Menu 29
7.16 Electronic drainer 30
8 Maintenance, troubleshooting, spare parts and dismantling 31
8.1 Checks and maintenance 31
8.2 Troubleshooting 32