Instruction manual

Page 8 of 27 040-1101-01 Rev C 5/19/2004 System Documentation

Quick Draw Post Installation

The Quick Draw post will need to be assembled to the cabinet. Follow the instructions

below to install the Gun, Holster and Quick Draw post. The nuts and bolts that are used

to assemble the Quick Draw post to the cabinet are located in the cash box just under

the Coin Mechs.

1. Unwrap the Quick Draw post from the packaging and unwrap the gun with holster,

which will be found inside the cabinet.

2. Begin by attaching the Quick Draw post to the cabinet by using 8x 10/32 x 1 T-25

Security Torx bolts shown by the arrows in the picture above. You will need to run

the Gun Holster’s wire harness through the post, and in through the hole on the front

of the cabinet to connect with the Gun Holster wire harness on the inside of the

cabinet.

3. Next, connect the gun’s 6 pin wire harness to the wire harness coming out the front

of the Quick Draw post shown by the circle in part A of the picture above. The two

spade connectors plug into the arcade button that is located on the bottom of the

Holster shown by the arrow in part A of the picture above. The black wire goes to the

bottom prong, the gray wire goes to the middle prong.

4. Place the Holster on top of the Quick Draw post and secure the Holster / Gun unit to

the Quick Draw post from the underneath side, using 2 x 10/32 bolts with washers

as shown in part B and C of the picture above. Attach the Ground wire with loop to

one of the bolts on the holster to prevent the gun from misfiring during game play

caused by electrical static shock.