Instruction manual

System Documentation 040-1101-01 Rev C 5/19/2004 Page 3 of 27
Copyright © 2004, All Rights Reserved
Safety
• The following safety instructions apply to all game operators and service personnel.
Specific warnings and cautions will be found throughout this manual where they
apply. We recommend that you read this page before preparing your arcade cabinet
for game play.
• Use the following safety guidelines to help protect the system from potential damage
and to ensure your personal safety.
• To help avoid damage to the computer, the power supply on the computer
automatically detects the voltage to match the AC power available at the location:
o 115 volts / 60Hz in most of North and South America and some Far Eastern
countries such as Japan, South Korea and Taiwan
o 230 volts / 50Hz in most of Europe, the Middle East and the Far East
• To help prevent electric shock, plug the system into properly grounded power
source. These cables are equipped with 3-prong plugs to help ensure proper
grounding. Do not use adapter plugs or remove the grounding prong from a cable.
If you must use an extension cable, use a 3 wire cable with properly grounded plugs
• To help protect your system from sudden, transient increases and decreases in
electrical power, use a surge suppressor, line conditioner or Uninterruptible Power
Supply (UPS).
• Be sure nothing rests on the system's cables and that the cables are not located
where they can be stepped on or tripped over.
• Do not spill food or liquid on the cabinet.
• Do not push any objects into the openings of the system. Doing so can cause fire or
electric shock by shorting out interior components.
• Keep your computer far away from radiator and heat sources.
• Always return the cabinets leg levelers to the extreme upright position before
attempting to move the game.
• Do not block cooling vents.
Warnings
WARNING
To avoid electrical shock, unplug the
cabinet before performing the installation
procedures.
GLOBAL VR assumes no liability for any
damages or injuries incurred while setting
up the cabinet. As such, only qualified
service personnel should perform this
installation!