Instruction manual

Page 24 of 27 040-1101-01 Rev C 5/19/2004 System Documentation

Trouble Shooting

Problem Possible Solution

No Picture or Distorted

Picture.

Check for bad video cable or faulty video board or

monitor. Check for loose or disconnected video

signal cable. Make sure the monitor has power.

Turn Game On and

Nothing Happens.

Check that the power cord is plugged into the

computer. Make sure the cabinet On/Off switch is

on. Confirm the power cord is plugged into a wall

outlet.

No Sound.

Check that the audio cable is connected to the

green audio port on the computer.

No Response from Gun.

Check that the signal and ground wires are correctly

connected to the Gun. Confirm the ACT LABS Gun

Module is plugged into the USB port on the

computer. Confirm the ACT LABS Gun Module

calibration switch is set to OFF.

No Response from Coin

Inputs and Operator

Buttons

You will need to verify that the Parallel Port Bios

settings are correctly setup for the computer, use

the instructions on page 21 to verify the computer

Bios settings.

No Credits given when

Coins are Inserted

Check coins per play setting. Verify the signal wires

are firmly connect to the coin mech. Check the

power wires going to the coin mech.

Too many Credits for

Number of Coins Inserted

Check coin per play setting in the game software.

Game Dongle not found

Check to make sure the GLOBAL VR USB Game

Dongle is connected to on the back of the computer.

If the USB Game Dongle is present and working

correctly it should light up with a Red LED. If the

dongle is not present plug it back in and reboot your

computer.