User guide

eWON 500-2001-4001-4002 User Guide - eWON Configuration
eWON 500®2001®4001®4002® Version 4_3_0 - User Guide - 10/5/05 - ©ACT'L sa - Page 36
4.3.6.1 Ethernet
This tab contains the Ethernet setup of the eWON, setting up the LAN side communication.
Figure 20: eWON Ethernet setup
• Versions older than 4.0 S8:
Click on the Update Ethernet Setup to validate your changes (eWON reboot is required).
• From version 4.0 S8:
No reboot if required if you only update the eWON Ethernet IP gateway.
Control Description
Address Setup
eWON Ethernet IP address
IP address of the eWON on the LAN side. Use this IP address to connect to the eWON using
a LAN connection. It is 4 numbers from 0 to 255 separated by a dot.
eWON Ethernet IP mask
eWON Ethernet server subnet mask, used to determine the address range of the LAN
connection (your network).
eWON Ethernet IP gateway
eWON Ethernet server gateway, which is the IP address used to forward information to other
networks. When a gateway IP address is set, ALL outgoing actions (except SMS) will pass by
the Ethernet gateway (no dial out using phone line will occur). That means that if you want to
redirect some actions through Ethernet and some other by phone (PPP), you then must leave
this field empty, or “0.0.0.0”.
eWON Use BOOTP
Forces eWON to wait its IP address from a BootP Server (see chapter “TCP/IP Bootstrap
Protocol (BOOTP)” on page 234).
DNS Setup
Primary DNS IP address
IP address, It is 4 numbers from 0 to 255 separated by a dot, of the primary Domain Name
Server of your domain or ISP provider.
Secondary DNS IP address
IP address, It is 4 numbers from 0 to 255 separated by a dot, of the secondary Domain Name
Server of your domain or ISP provider.
Table 15: eWON Ethernet setup configuration page