User guide

eWON 500-2001-4001-4002 User Guide - eWON Configuration
eWON 500®2001®4001®4002® Version 4_3_0 - User Guide - 10/5/05 - ©ACT'L sa - Page 30
4.3.3.4.2 Web configuration
You get access to the COM1 (or COM2) VIRTUAL PORT CONFIGURATION page by following this path from the Main Menu navigation bar:
Configuration/System Setup/General/Virtual Com (from the General menu):
Figure 15: eWON Virtual COM port configuration page
You may first choose the COM port you want to configure in the COM Port: scrolling menu.
You can then define the following parameters:
Control Description
Port Type If Disabled is selected, then VCOM will not be used on this port.
TCP Port
The PC will have to connect to that TCP/IP port to communicate through the eWON serial port.
REM: if multiple VCOM are defined on the same eWON, they must all use a different TCP/IP port.
Poll Signal Interval
This parameter is only used in TELNET RFC2217 mode. In that mode the eWON will scan the modem
port for changes in modem line input levels (CTS, DSR, DCD, RING) thus this parameters defines the
scan rate. The default value of 100msec should be faster enough for most applications.
Debug: Will enable debug logging in the real time event log
($dtRE, see “Export Block Descriptor” on page 192).
Table 11: eWON virtual COM port configuration controls