User guide

eWON 500-2001-4001-4002 User Guide - eWON Configuration
eWON 500®2001®4001®4002® Version 4_3_0 - User Guide - 10/5/05 - ©ACT'L sa - Page 26
4.3.1.3 Resetting eWON
Resetting eWON is sometimes necessary (i.e. to validate some configuration changes).
eWON version 4 offers two ways to perform a reset:
• From the General configuration page (chapter “Reset Request from the General Configuration page” on page 26)
• By using the "REBOOT" Basic command, as described in chapter “REBOOT” on page 161.
4.3.1.3.1 Reset Request from the General Configuration page
This way of resetting eWON did not change since version 3. You always can reset eWON by validating the checkbox that stands at the very
bottom of the main (general) configuration of eWON web site, on which you access this way from the Main Menu navigation bar:
Configuration/System setup/General/General (Main submenu):
Figure 12: eWON General system setup – Reset Request
Any change that you enter in the General configuration page (or for example changing the eWON IP address) requires that you perform a first
level reset of eWON for this change to be validated. Activating the Reset request checkbox, then clicking on the Update Config button triggers
the reset process. You will have to wait that eWON comes back to its normal state after restarting to get access to it again.
4.3.2 SNMP Setup
The second page from the System setup is the SNMP setup. All the global SNMP management is done here.
Figure 13: eWON SNMP setup main menu page