System information

General Reference Guide eWON Configuration
RG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 82
3.7.2 The Script control link
This page is used to monitor the result of the script execution and to execute some commands manually. You can use this page to easily debug
your program.
Figure 69: eWON script control page
To display the result of the script execution, 2 actions must be performed:
• Start the script execution by clicking on the RUN link.
• Click on the Update Output button to update the display of the result screen.
It’s also possible to execute one-shot commands. Just fill in the blank field with the command to execute and then click on the Execute
Command button.
Validate the Script starts at eWON Boot checkbox to start the script automatically when the eWON boots. This change will be validated after
you have clicked on the Update Autorun mode button.
3.7.3 The RUN/STOP link
This link is used to start or stop the script execution.