System information

General Reference Guide eWON Configuration
RG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 76
3.4.2.2.1 Email on alarm configuration
The required configuration if an email must be sent in case of alarm. If an email must be sent through PPP, the system configuration (Main and
COM) must also be set up.
3.4.2.2.2 SMS on alarm configuration
Warning: Sending an SMS is only possible from an eWON that embeds a modem (c.f. Table 187 on page 203)
Alarm action Properties Description
Email upon Checks the alarm states triggering an email (ALM, ACK, RTN, END).
Short Message
In some cases it is useful to have the whole message sent in the subject. For example if you
need to route email to SMS.
Usually this checkbox is disabled.
Email To List of TO email address comma (, or ;) separated.
Email CC List of CC email address comma (, or ;) separated.
Email subject Will be the subject of the email (except if short message is selected).
Email attachment
Body text of the email.
This text can include Export Block Descriptor inline with text or as attachment.
Attachments to include in the Email must follow the syntax:
&[EXPORT_BLOC_DESCRIPTOR_1] &[EBD_2]…
There can be as many attachments as required.
EXPORT_BLOC_DESCRIPTOR syntax is described in chapter “Export Block Descriptor” on
page 167
Example:
&[$dtRTGA_AN01$ftG] &[$dtEV$ftT]
Will export Real time data of GA_AN01 as a graph and the event log file as a text file.
Table 49: Email on alarm configuration controls
Alarm action Properties Description
SMS upon Checks the alarm states triggering an SMS (ALM, ACK, RTN, END).
SMS Destination
A list of SMS_RECIPIENT; SMS_RECIPIENT;…
See below for the SMS_RECIPIENT syntax.
SMS Subject Will appear at the beginning of the SMS message.
Table 50: SMS on alarm configuration controls