System information

General Reference Guide eWON Configuration
RG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 51
note: If Network Connection is on Ethernet WAN connection, the Ethernet interface is not active as long as the WAN is not
connected.
See "Ethernet WAN Connection - Disconnection sequence (since firmware 5.4)" on page 48
note: If Network Connection is on ADSL, and you want to allow devices connected on the eWON-LAN to go on Internet, don’t forget
to set the Routing to NAT and TF on WAN (See "Routing" on page 55).
3.3.4.3.2 VPN connection
Figure 40: VPN connection setup page
“On demand” Internet connection
Dial On Demand
It is possible to establish remote connections towards the ISP by using the Dial On Demand
feature. If selected, the eWON will try to connect to the ISP each time a connection will be
required (i.e. packets to send). Those fields allow you EITHER to exclude OR to select IP
addresses ranges that are allowed or refused for Dial On Demand. Four different IP
addresses ranges can be defined.
Note: those fields will be updated at each new PPP connection.
Important: By default, the Dial On Demand is configured to refuse all connections.
Control Description
VPN use conditions
During Internet connection
Set here how eWON will use the VPN. Choose among the 3 choices:
• Disable VPN
• Listen for incoming VPN from Client
• Establish outgoing VPN to server
Table 34: Internet connection parameters