System information

General Reference Guide eWON Configuration
RG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 36
On eWONs with two ethernet interfaces (eWON2005 or 4005), the WAN configuration page will be one of the followings:
IMPORTANT: Since firmware 5.4, on eWON with 2 ethernet interfaces, the WAN ethernet interface is disconnected by default.
See "WAN/LAN/PPP interface management" on page 47
3.3.4.2.1.2 BootP : TCP/IP Bootstrap Protocol
You can force eWON to ask its IP address to a BootP Server.
Only the IP address and network mask are given by the BootP server.
To correctly set the IP address and mask, your BootP server must comply with the RFC-1048.
At each startup, the eWON will receive its IP address from the BootP Server.
The eWON will wait for the server unless it is already present.
The eWON will perform a new attempt at increasing interval (1 minute interval max.) endlessly.
While waiting for its IP address, the eWON is in startup phase and thus it is not functioning! During this time, the USER LED will
blink continuously with the following pattern:
Resolution:
1) Pushing on the Reset button (on the front side of the eWON) will skip the BootP request, then eWON will use the IP address which is
configured in the Ethernet configuration page
The Duplicate IP test is skipped too!
2) Make a Second Level Reset (see chapter “Second level reset” on page 201) to force eWON to 10.0.0.53 IP address and to disable
the BootP mechanism
eWON is now accessible.
3.3.4.2.1.3 DHCP : Dynamic Host Configuration Protocol
Configured on DHCP, the eWON gets all the IP parameters from the DHCP server.
These parameters are: the IP address, network mask, default gateway and the 2 DNS servers. The DNS servers can optionally be defined
statically.
At the end of the DHCP request, the User Led will blink continuously with the following pattern during 2 seconds:
Note: If the eWON doesn’t find any DHCP server, after 45 seconds, it will take the IP 169.254.0.53 with mask 255.255.0.0
Static BootP DHCP
Table 28: Two ethernets : WAN configuration pages
short red light + pause + long green light + pause
short red light + short pause