System information

General Reference Guide Upgrading the eWON firmware
RG-001-0-EN ver 1.5 eWON® - 20/03/2009 - ©ACT'L sa Page 196
• Simply drag the new firmware to be uploaded (from your local hard disk or from another FTP folder) and drop it to the root of the
eWON file system (here the window is named "10.0.120.11"). A confirm window will appear asking you the action to be performed.
Figure 139: eWON firmware overwrite confirmation window
• Click on the Overwrite button and wait the fill in (blue) of the progress bar in the left bottom side of the window.
Figure 140: eWON upload firmware action
• Click on the “Disconnect” icon to exit the connection to the eWON and quit the SmartFTP program.
WARNING:
When you click on the “Disconnect” icon, the eWON begins a flash memory programming operation (about one minute long).
Do NOT power off the eWON during this operation. If you have a look at the eWON STATUS led, it will be blinking red about once a
second. When it finishes blinking, the eWON will reboot. The reboot operation can be observed on the Ethernet link led, going off
and then back on again.
Please do NOT remove power until you can get access to the eWON using your web browser of FTP browser. Failure to do so can
lead to the destruction of the eWON and a factory return would be unavoidable.