User's Manual Part 2

T
2
CAS / Part No. 9000000
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
34-43-20
15 Feb 2003
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
9--1
CLEANING/PAINTING
1. General
While the T
2
CAS Traf fic and Terrain Collision Avoidance System is installed in the aircraft,
cleaning is limited to the procedures given below. Painting and more extensive cleaning
should be done during shop maintenance when the LRUs can be disassembled. Detailed
instructions are given in each applicable component--level maintenance manual.
2. Equipment and Materials
W ARNING: BEFORE YOU USE A MATERIAL, REFER TO THE MANUFACTURERS’ MATERIAL
SAFETY DATA SHEETS FOR SAFETY INFORMAT ION. SOME MATERIALS CAN BE
DANGEROUS.
Table 9--1 gives the equipment and materials required for cleaning and painting.
Table 9--1. Equipment and Materials
Name Description Source
Abrasive paper No. 600, nonconductive abrasive Optional source
Air supply Air ionizing nozzle gun
attachment for compressed air
(20 psi)
Optional source
Cleaning brush Soft, natural--bristle
(camel hair)
Optional source
Glass cleaner Ammoniated Optional source
Lens tissue Lint Free Optional source
Sandpaper Grit sizes 220 and 400 Optional source
HMN 110C878 Catalyst, polyurethane — No.
V66V44(--4)
Sherwin--Williams Co,
Cleveland, OH
HMN 110C978 Reducer, polyurethane — No.
R7K84
Sherwin--Williams Co,
Cleveland, OH
HMN 1130778 Solvent — Isopropyl alcohol
(99%), semigrade
Optional source
HMN 6008676 Lint free cloth — Bluewipes, No.
TX512
Texwipe Co,
Upper Saddle River, NJ