User's Manual Part 2

T
2
CAS / Part No. 9000000
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
34-43-20
15 Feb 2003
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
7--3
(a) If APM is attached to the T
2
CAS mounting tray, remove the screws that attach
the APM to the T
2
CAS mounting tray.
(b) Loosen the screws that attach the APM to the APM Mating Connector.
(c) Carefully disconnect the APM from the APM Mating Connector.
(2) Reinstall the APM.
(a) Carefully insert the APM connector plug into the APM Mating Connector.
(b) Tighten the screws that attach the APM to the APM Mating Connector.
(c) If APM is to be attached to the T
2
CAS mounting tray, reattach the APM to the
T
2
CAS mounting tray using the provided mounting screws.
NOTE: If a new APM (blank or previously programmed for a different aircraft) is installed,
the APM must be reprogrammed as specified in Adjustments/Test, section 6--D.
B. Adjustment Procedure
Not Applicable.
C. Repair Procedure
The ACSS APM is a non--repairable item. If the APM is damaged or determined to be
faulty, it must be replaced with a new APM.
D. Return to Se rvice Proce dures
Do the Return to Service Te st Procedures referenced in the ADJUSTMENT/TEST section
of this manual.