User's Manual Part 1

T
2
CAS / Part No. 9000000
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
34-43-20
15 Feb 2003
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
1--3
Table 1--2. System Components Not Manufactured by ACSS
Component Comments
Gables G7130 Series ATC/TCAS Dual Transponder Control
Panel (Note 1.)
General aviation type controller that
operates from 28 V dc aircraft power
(Note 2.)
Gables G6990, G6991, G6992 and G6993 Series
Mode S/TCAS Control Panels (Note 1.)
Commercial aviation type controllers
that operate from 115 V ac aircraft
power (Note 2.)
Gables G7491
Flight ID Control Panel
Commercial aviation type Flight ID
Control Panel that operates from 115
V ac aircraft power (Note 2.)
Omnidirectional TCAS Antenna (Note 4.) ATC blade antenna, dc shorted, TSO
C119b compliant,1030 to 1090 MHz.
Installer to supply antenna.
Omnidirectional ATC Antennas (Note 5.) ATC blade antenna, dc shorted, TSO
C112 compliant, 1030 to 1090 MHz.
Installer to supply antenna.
GPS Antenna Coax Cable TBD
Thales VSI/TRA (Note 3.) High resolution LCD flat panel Vertical
Speed Indicator with TCAS II data in
RA and TA modes.
Mounting Tray, T
2
CAS Computer (6--MCU size unit) ARINC 600 6--MCU Mount, cooling air
required. Installer to supply mount.
Mounting Tray, T
2
CAS Computer (4--MCU size unit) ARINC 600 4--MCU Mount, no cooling
air required. Installer to supply mount.
Mounting Tray, Data Link Transponder (4--MCU size unit) ARINC 600 4--MCU Mount, cooling air
recommended but not required.
Installer to supply mount.
NOTES:
1. Refer to Table 1--4 for individual part number descriptions.
2. For additional information, pricing and availability contact:
Gables Engineering, Inc. 247 Greco Avenue, Coral Gables, Florida 33146
Telephone (305) 774--4400
Fax (305) 774--4465
3. For additional information, pricing and availability contact:
Thales Communications, Inc.
Aviation Electronics Division
22605 Gateway Center Drive
CLARKSBURG, MD 20871--2001, USA
Telephone +1 (240) 864--7639
4. A bottom omnidirectional antenna can be used as an optional replacement for the directional
antenna.
5. A diversity transponder installation requires both a top and bottom ATC antenna.