User's Manual
Table Of Contents
- T3CAS_Section_5
- 5 Adjustment/Test
- 1. General
- 2. Equipment
- 3. Initial Harness Checkout (New Installations Only)
- 4. System Self-Tests
- 5. Return-to-Service Test
- 6. Operational Software Loading Using an ARINC 615A Portable Data Loader or Compact Flash Card
- 7. Downloading Information from the TP3PCAS Using a CF Card
- 1. Obtain a New or Blank Compact Flash (CF) card.
- 2. Copy to the New or Blank CF card the appropriate ‘Header File’
- a) Header files are files copied to the New or Blank CF card that will instruct the computer unit what is desired to be downloaded.
- b) Header files needed to download Maintenance Data, Event Data and CRC Part Numbers can be obtained from ACSS Customer Services at +1-623-445-7070 or crc.acss@l-3com.com.
- 3. For downloading Maintenance Data, Event Data or CRC Part Numbers the aircraft does not need to be in an on-ground configuration.
- 4. Apply power to the computer unit.
- 5. Insert the CF card.
- 6. For ACSS part numbers 9005000-10000, -10101, -10202, and -10204 the DATA STATUS LED will UblinkU green once; this indicates the unit recognized that a CF card was inserted.
- 7. For ACSS part numbers 9005000-11203, -11801 and -55801 the DATA STATUS LED will UblinkU green while reading the header file and performing the action defined in the header file.
- 8. Flight Data Recording
- 1. T3CAS part numbers 9005000-10000, -10101, -10202, and -10204 only support FAT16 CF card formatting. T3CAS part numbers 9005000-11203, -11801 and -55801 support both FAT16 and FAT32 CF card formatting.
- B. Flight Data
- 1. Obtain a New or Blank CF Card.
- 2. Copy to the New or Blank CF Card the Appropriate Header File.
- 3. Header files are files copied to the New or Blank CF card that will instruct the computer unit what is desired to be downloaded.
- 4. For Flight Data Recording, the aircraft does not need to be in an on-ground configuration.
- 5. Apply power to the computer unit.
- 6. Insert the CF card.
- B. Flight Data
- 9. Downloaded Maintenance Data, Event Data And Flight Data May Be Sent To ACSS Customer Services For Analysis
- 5 Adjustment/Test
- T3CAS_Section_6
- T3CAS_Section_7
- 7 Maintenance Practices
- 1. General
- 2. Equipment and Materials
- 3. Procedure for the TP3PCAS Computer Unit
- 4. Procedure for the APM (Not applicable for part numbers 9005000-10000, -10101, -10202, -10204, or -11203)
- 5. Procedure for the Directional Antenna
- 6. Procedure for the Omnidirectional Antenna (Applicable to part numbers 9005000-11203, -11801 and -55801)
- 7. Procedure for the Control Panel
- 8. Procedure for the VSI/TRA Display
- 9. Instructions for Continued Airworthiness, FAR Part 25.1529
- 7 Maintenance Practices
- T3CAS_Section_8
- T3CAS_Section_9
- T3CAS_Section_10
- T3CAS_Appendix_A
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
T
3
CAS/Part No.9005000
Table 4-1: T
3
CAS Computer Unit Interface Description (cont)
(Applicable to Part No. 9005000-10000, -10101, -10202, -10204, and -11203)
Connector
Pin
Designation
Functional Description
RMP-12B
(Continues)
Radio Altimeter Type Select Program Input No.4 (NO)
The T
3
CAS computer unit uses radio altitude to inhibit advisories and aural
annunciation when in close proximity to the ground. This analog input No.1, as well
as analog input No.2 can accept data as a dc voltage from several types of radio
altimeters. Program pin RMP-12B is used, along with program pins RMP-12D, -
12E, and -12F, to identify the type of analog radio altimeter installed.
For T
3
CAS CU ARINC 552, Collins BCA, AHV-6, NR-AS-10A, LPIA, APN-232
CARA and metric type radio altimeters can be selected. The program pin inputs
use ground/open logic levels. All unassigned program pin combinations are invalid
and should not be selected. Pin RMP-6K can be used to supply a ground.
Program Pin
RMP-12F RMP-12E RMP-12D RMP-12B Altimeter Type
Open Open Open Open ARINC 552/552A
Open
Open
Open
Ground
Collins BCA
Open
Open
Ground
Open
Metric Altimeter No.1
Open
Open
Ground
Ground
Unassigned
Open Ground Open Open Metric Altimeter No.2
Open
Ground
Open
Ground
Unassigned
Open
Ground
Ground
Open
Metric Altimeter No.3
Open Ground Ground Ground Unassigned
Ground
Open
Open
Open
Metric Altimeter No.4
Ground
Open
Open
Ground
Unassigned
Ground Open Ground Open Military AHV6 (Linear)
Ground Open Ground Ground Military AHV6 (Log)
Ground Ground Open Open
Military NR-AS-10A
(Alternate)
Ground
Ground
Open
Ground
Military APN-232 CARA
Ground
Ground
Ground
Open
Military LPIA
Ground Ground Ground Ground
Military NR-AS-10A (Curve
Fit)
The Radio Altitude sources listed are defined by the following:
Pub. No. 8600200-001, Revision 004
34-45-29
4-19
04 Nov 2014
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.