User's Manual

Table Of Contents
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
T
3
CAS/Part No.9005000
Figure 6-10: Help Reference Page
In addition to the recommended procedure, the number 2 transponder
must be selected on the Mode S/TCAS control panel and the mode
select switch placed in TA only or TA/RA mode momentarily prior to
restarting self-test to enter extended maintenance mode.
(h) Suppression Bus Fail Page
The Suppression Bus Fail page, Figure 6-11, is displayed only when a
TCAS suppression bus failure is indicated and the 4096 Ident Code is
0010. This page displays information about detected suppression bus
failures. It briefly describes the problem and instructs maintenance
personnel to change the 4096 Ident Code to display the Suppression
Bus Clear page for clearing instructions. If there is no suppression bus
failure, the main menu (0000) is displayed.
Figure 6-11: Suppression Bus Fail Page
6-26
04 Nov 2014
34-45-29
Pub. No. 8600200-001, Revision 004
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.