User's Manual

SYSTEM DESCRIPTION AND INSTALLATION MANUAL
T
3
CAS/Part No.9005000
3. Header files are files copied to the New or Blank CF card that will instruct the
computer unit what is desired to be downloaded.
4. For Flight Data Recording, the aircraft does not need to be in an on-ground
configuration.
5. Apply power to the computer unit.
6. Insert the CF card.
a) The DATA STATUS LED will
blink green once. This indicates the unit
recognized that a CF card was inserted.
b) The DATA STATUS LED will then remain a
solid green while reading
the header file.
c) The DATA STATUS LED will then
blink until data recording is cancelled
by removing the CF card.
NOTE:
If for any reason the data transfer fails, you wil get an amber
DATA STATUS LED. If the unit detects a bad media or
configuration file, you will get a
blinking amber DATA
STATUS LED. If this occurs, inspect the CF card, inspect the
CF slot, inspect the connections and attempt the download
again.
9. Downloaded Maintenance Data, Event Data And Flight Data May Be Sent To ACSS
Customer Services For Analysis
A. Phone
Contact ACSS Customer Services for instructions on where to transmit data files.
ACSS Customer Services [phone]
B. Mail
In the case of flight test data, it may fill a CF card entirely. Flight test data recording uses
up to 1 megabyte/minute of flight time. Since these files are large, the card can either be
mailed or delivered by courier. Please address your properly packaged CF card to the
following address:
ACSS Customer Services
19810 N. 7th Avenue
Phoenix, AZ, 85027-4741, USA
C. Email
Maintenance data and event data files are around 4 megabyte in size and can be easily
emailed to Customer Services at
[e-mail] for analysis.
5-26
04 Nov 2014
34-45-29
Pub. No. 8600200-001, Revision 004
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.