User Instructions

SECURITY NOTATION SPEC

NO.

IT4061400-907

SEE PAGE INDEX

FOR THIS SHEET

REV LETTER

CAGE

CODE

58960

REV LTR

SEE THE TITLE PAGE FOR PROPRIETARY AND DATA RIGHTS NOTATIONS.

REV

LTR

AW/CRITICAL NOTATION

SUPPLEMENTS

SECURITY NOTATION PAGE

15101-000 (REV 970213 BCAS ASF5900/ENG_SPEC.DOT) (REV 07/18/2000 -OFC97-DATA SERVICES) HONEYWELL INTERNATIONAL INC.

ENGINEERING

SPECIFICATION

TITLE: INTEGRATED TEST SPECIFICATION FOR MODE S TRANSPONDER, PART NO.

4061400-9XX

1. SCOPE

This Integrated Test Specification (IT) establishes the manufacturing and operational requirements

that the Mode S Transponder, Part No. 4061400-9XX, must meet to ensure that the unit is in

proper operating condition.

2. REFERENCE DOCUMENTS

These reference documents are not required for performance of the test procedure. The purpose

of listing these documents is to provide an aid for troubleshooting should any discrepancies occur

during the performance of the test procedure.

4061400-9XX End Item Drawing - Mode S Transponder

4061401 Outline and Installation Drawing

64980-90912 HP 64000 System Overview Reference

64980-90928 HP 64000 System Software Reference

1002-6801-000 IFR 1403 Operation/Maintenance Manual

C35-3641-05 System Control Panel User's Manual

3. GENERAL INFORMATION

3.1

All tests shall be performed under the following conditions:

Temperature = 25 ± 5 C

Relative humidity = 95% maximum

Pressure = between 20 and 32 inHg

3.2 Tests 1 thru 10 shall be performed with the HP 64000/UDE or PC/CPI emulation system attached to

the top connector of the unit under test (UUT) A1 CCA (refer to figure 1). All subsequent tests shall

be performed in a stand-alone configuration with the emulation system removed or deactivated.

Power to the UUT shall be removed before attaching or removing any interconnecting systems.