User Instructions

SECURITY NOTATION SPEC
NO.
IT4061400-907
SEE PAGE INDEX
FOR THIS SHEET
REV LETTER
CAGE
CODE
58960
REV LTR
SEE THE TITLE PAGE FOR PROPRIETARY AND DATA RIGHTS NOTATIONS.
REV TEST SPECIFICATION PROCEDURE SPECIFICATION
LTR NO. OPR LIMITS C TEST DESCRIPTION SWITCH POS C WORK STEPS MFG LIMITS
AW/CRITICAL NOTATION
SUPPLEMENTS
33
SECURITY NOTATION PAGE
15101-000 (REV 970213 BCAS ASF5900/ENG_SPEC.DOT) (REV 07/18/2000 -OFC97-DATA SERVICES) HONEYWELL INTERNATIONAL INC.
ENGINEERING
SPECIFICATION
Sig/Lamp Signal Name Signal Name Sig/Lamp
6.4 GND/OFF
OPN/ON
(Red)
+5V/ON
(Red)
OPN/OFF
ALT FAIL 1
ALT FAIL 2
XPDR FAIL 1
XPDR FAIL 2
ALT FAIL 1
ALT FAIL 2
XPDR FAIL 1
XPDR FAIL 2
GND/OFF
OPN/ON
(Red)
+5V/ON
(Red)
OPN/OFF
7 SYNCHRO ALTITUDE
SYNCHRO ALTITUDE
Perform test setup in
accordance with table 2.
Perform test setup in
accordance with table 2.
Stimulate the UUT
SYNCHRO REF H and
SYNCHRO REF C signals
with a 26 V ac, 400 Hz
sinusoidal waveform.
Stimulate the UUT
synchro altitude inputs
with a second 400 Hz
sinusoid that is
synchronous with the
reference signal (above).
Apply this signal across
the following UUT synchro
inputs with the negative
side of the signal
connected to the Z input:
Mode S
Interface
Panel
26 VAC POL
= +
On the Mode S interface
panel, connect the 26 V
ac REF + and - signals to
the Sync Alt 1/2 RH and
RC signals. Connect the
TEST VAC + signal to the
FX, FY, CX, and CY
signals. Connect the
TEST VAC - signal to the
FZ and CZ signals.
Adjust the amplitude of
the TEST VAC signal to 9
V rms.
SYNC ALT 1 FINE X-Z
SYNC ALT 1 FINE Y-Z
SYNC ALT 1 CRSE X-Z
SYNC ALT 1 CRSE Y-Z
SYNC ALT 2 FINE X-Z
SYNC ALT 2 FINE Y-Z
SYNC ALT 2 CRSE X-Z
SYNC ALT 2 CRSE Y-Z