User Instructions

SECURITY NOTATION SPEC
NO.
IT4061400-907
SEE PAGE INDEX
FOR THIS SHEET
REV LETTER
CAGE
CODE
58960
REV LTR
SEE THE TITLE PAGE FOR PROPRIETARY AND DATA RIGHTS NOTATIONS.
REV TEST SPECIFICATION PROCEDURE SPECIFICATION
LTR NO. OPR LIMITS C TEST DESCRIPTION SWITCH POS C WORK STEPS MFG LIMITS
AW/CRITICAL NOTATION
SUPPLEMENTS
27
SECURITY NOTATION PAGE
15101-000 (REV 970213 BCAS ASF5900/ENG_SPEC.DOT) (REV 07/18/2000 -OFC97-DATA SERVICES) HONEYWELL INTERNATIONAL INC.
ENGINEERING
SPECIFICATION
3.1 N/A Enter "SW IT30P" N/A
Enter "run from startup"
NOTE: EEPROM is only
8 bits wide, instead of 16.
If 16 bits of data are
specified, only the least
significant 8 bits are used.
Thus, FE34H is the same
as 34H.
Write the EEPROM
address (00H thru FFH) to
each location in EEPROM
(8000H thru 9FFFH).
Verify each location.
Program will take several
minutes to complete.
Front panel LEDs shall
flash in a repetitive pattern
while the program is
executing. When the
program is complete all
six LEDs shall be
illuminated.
Write the complement of
each EEPROM address
(FFH thru 00H) to each
location in EEPROM
(8000H thru 9FFFH).
Verify each location.
Write the value FFH to
each location in EEPROM
(8000H thru 9FFFH).
Verify each location.
Write the LRU dash and
serial numbers, in ISO-5
format, to the EEPROM
locations 9FC0H to
9FCAH.
Enter "modify register
CACHE to 0"
3.2 PASS Enter "display memory
20010H thru 20011H"
Look in the ASCII decode
display for the Pass/Fail
indicator. Status shall be
as indicated.
PASS
Enter "modify register
CACHE to 1"