WALL MOUNTED SPLIT TYPE AIR CONDITIONER MANUAL OM-G12-ACSON 8
CONTENTS - Operating Guide - G12 Remote Controller Indication - Indicator Lights - Installation of Aroma - Auto Random Re-Start Function - Service and Maintenance - Troubleshooting page 1 page 2 page 4 page 5 page 5 page 5 page 6 OPERATING GUIDE 1. Transmission source • The source where the signal will be transmitted. 2. Signal transmission indication • Blink to confirm that the last setting has been transmitted to the unit. 3. “ON/OFF” Button • Press once to start the air conditioner unit.
G12 Remote Controller Indication 1 2 4 13 9 3 8 12 14 6 7 11 5 10 Key Function Actions RECALL PRESS ONCE for P1 & TWICE FOR P2 PRESS & HOLD BUTTON for 3s to INITATE PERSONALISED SETTING PROGRAM SELECT P1 OR P2 SET INDIVIDUAL SETTINGS eg. MODE, SET TEMP or FAN SPEED LEAVE for 4s to SAVE CLOCK REAL TIME CLOCK (RTC) PRESS & HOLD BUTTON for 2s to ACTIVATE PRESS '+' or '-' to DESIRED TIME LEAVE for 4s to SAVE Part No.
HOW TO MOUNT ONTO THE WALL TO INSERT BATTERIES 3
INDICATOR LIGHTS IR signal receiver When an infrared remote control operating signal has been transmitted, the signal receiver on the indoor unit will make a sound to confirm acceptance of the signal transmission. IR Receiver LED indicator lights Cooling unit The table shows the LED indicator lights for the air conditioner unit under normal operation and fault conditions. The LED indicator lights are located at the middle of the air conditioner unit.
INSTALLATION OF AROMA 1 2 3 4 1 2 3 4 Unscrew the air discharge housing. Flip open the air discharge housing. Remove the aroma tray from the bracket as shown in the picture, replace the new aroma tray into the bracket. Close the air discharge housing and thighten it with screw. ! Caution 3. The filter is a consumable part which you can purchase from your air conditioner dealer. 4. Use the new filter immediately once it has been taken out from its sealed packing.
1 2 3 4 5 Off the unit. Unscrew the air discharge housing. Flip open the air discharge housing. Clean the blower. Close the air discharge housing and tighten it with screw. ! Caution Do not operate any heating apparatus too close to the air conditioner unit. This may cause the plastic panel to melt or deform as a result of the excessive heat. When The Unit Is Not To Be Used For An Extended Long Period Of Time Operate the unit for 2 hours with the following setting. Remove the power plug.
• In the event that there is any conflict in the interpretation of this manual and any translation of the same in any language, the English version of this manual shall prevail. • The manufacturer reserves the right to revise any of the specification and design contain herein at any time without prior notification. OYL MANUFACTURING COMPANY SDN. BHD. JALAN PENGAPIT 15/19, P.O. BOX 7072, 40702 SHAH ALAM, SELANGOR DARUL EHSAN, MALAYSIA.
