Installation guide

Connection Diagram - Serial Interface
Scheme 6: USB reader, Internal USB extension cable.
One special USB extension cable is required:
•
•
A shielded USB cable with “2x5 pins plug” on both
ends.
Wiring Procedures:
1. First, connect the one end (2x5 pins plug) of the
USB cable into the 2x5 pins header of the reader.
2. Second, connect the other end (2x5 pins plug) of the
USB cable into the internal USB port (2x5 pins
header) on the motherboard.
N.B. Please pay attention to the plug orientation.
Scheme 7: USB reader, Internal USB extension cable.
One special USB extension cable is required:
A shielded USB cable with “2x5 pins plug” on one
end and a type A plug on the other end.
Wiring Procedures:
1. First, connect the one end (Type A plug) of the USB
cable into the Type A header of the reader.
2. Second, connect the other end (2x5 pins plug) of the
USB cable into the internal USB port (2x5 pins
header) on the motherboard.
N.B. Please pay attention to the plug orientation.
2.
1.
ACR30 Series Installation Guide Page 28 of 28
Advanced Card Systems Ltd.
Unit 1008, 10th Floor
Hongkong International Trade and Exhibition Centre
1 Trademart Drive
, Kowloon Bay, Hong Kong
Tel: [phone] Fax: [phone]
Website: www.acs.com.hk Email: [e-mail]