Installation guide

Connection Diagram - Serial Interface
Scheme 2:
RS232 reader cable linked to a metal panel, another
cable linked to the RS232 port.
Two extension cables are required:
•
•
•
A flat cable with a “2x5 pins plug, 2.54mm pitch” on
the one side while the other side is connected to a
“DB9(F) connector with metal panel”.
A serial extension cable “DB9(F) to DB9(M)”
Wiring Procedures:
1. Firstly, connect the 2x5 pins Plug of the flat cable
into the 2x5 pins Header on the PCB of the reader.
2. Secondly, fix the “DB9(F) with metal panel” on the
slot hole of the PC Chassis.
3. Finally, connect any unused Serial Port and the
“DB9(F) with metal panel fixed on the PC
Chassis” together with the “serial extension cable”
Scheme 3:
RS232 reader, using an additional RS-232C Card
An extension cable and a RS-232C card are required:
A flat cable with “2x5 pins plug, 2.54mm pitch” on
both sides.
An additional RS-232C Card is required. Only one serial
port is required. However, many RS-232C cards come
with 2 serial ports.
Wiring Procedures:
1. Firstly, connect the 2x5 pins Plug of the flat cable
into the 2x5 pins Header on the PCB of the reader.
2. Secondly, plug the provided RS-232C card into any
available ISA slot of the motherboard.
3. Finally, connect the 2x5 pins Plug at the other end
of the same flat cable into the 2x5 pins header
socket on the additional RS-232C card.
Remark: Card Slot Interface must be taken into
consideration, because few motherboards
nowadays still support ISA slots!
3.
2.
1.
2.
3.
1.
ACR30 Series Installation Guide Page 26 of 28
Advanced Card Systems Ltd.
Unit 1008, 10th Floor
Hongkong International Trade and Exhibition Centre
1 Trademart Drive
, Kowloon Bay, Hong Kong
Tel: [phone] Fax: [phone]
Website: www.acs.com.hk Email: [e-mail]