Installation guide

Connection Diagram - Serial Interface
Appendix B: Connection Diagram – Serial Interface
ACR30S/SP
To connect the ACR30S/SP device to your PC:
1. Connect the 9-PIN Serial Connector to the
serial/COM Port. If you only have a 25-pin COM
port, you may need a 9-PIN to 25-PIN adapter.
2. Connect the round PS/2 connector to the PS/2
port. This is usually where your keyboard or
mouse is plugged in, so you may need to
disconnect the keyboard/mouse connector first.
3. Connect the keyboard or mouse connector to the
PS/2 Extension Plug (see diagram) of the Smart
Card Reader.
Note: For the Smart Card Reader to work properly; make
sure that both the serial connector and the PS/2
connector are connected to your PC.
ACK30S
To connect the ACK30S device to your PC:
1. Connect the PS/2 Connector to the PS/2 Port.
2. Connect the 9-PIN Serial Connector cable to the
Serial/COM Port.
Note: For the Smart Card Reader to work properly; make
sure that both the serial connector and the PS/2
connector are connected to your PC.
ACF30S
Scheme 1:
RS232 reader, using one extension cable coming out
from the back of PC.
One extension cable is required:
• A flat cable with a “2x5 pins plug, 2.54mm pitch”
on the one side while the other side is connected to
a “DB9(F) connector”.
Wiring Procedures:
1. Firstly, connect the DB9(F) of the extension cable to
any unused Serial Port externally.
2. Secondly, let the 2x5 pins Plug go through the slot
hole of the PC Chassis.
3. Finally, connect the 2x5 pins Plug of the flat cable
into the 2x5 pins header on the PCB of the reader.
1.
2.
3.
ACR30 Series Installation Guide Page 25 of 28
Advanced Card Systems Ltd.
Unit 1008, 10th Floor
Hongkong International Trade and Exhibition Centre
1 Trademart Drive
, Kowloon Bay, Hong Kong
Tel: [phone] Fax: [phone]
Website: www.acs.com.hk Email: [e-mail]