Installation guide

How to Check your Installation
1.2 How to Check your Installation
To check if you have properly installed your smart card reader, you can either use the ACS Diagnostic Tool
– QuickView or the Windows Device Manager.
A. Using ACS Diagnostic Tool – QuickView
ACS QuickView is available at the ACS Card Utility/Tool Download website, http://www.acs.com.hk/CU.asp.
Connect the ACR30U, ACF30U, ACT30, ACK30U, and
ACR30D to your PC. Run QuickView.exe. Click
“Initialize” to start the driver diagnosis.
If the device driver is successfully installed into your PC,
the name of corresponding driver (PC/SC or ACS
Synchronous) will be displayed.
QuickView is applicable for both PC/SC driver and
ACS Synchronous API Driver (Proprietary Driver)
B. Using Device Manager
To check if you have properly installed your smart card reader, open the Device Manager.
B.1 For ACR30U/ACT30/ACF30U/ACK30U
Windows XP/2000 ACS Driver Installer
To start the Device Manager on Windows XP/2000,
select Start → Settings → Control Panel. Double-
click on System, click the Hardware tab, and then
click on Device Manager.
For PC/SC Drive
r
The Windows Device Manager should list the ACS USB
Smart Card Reader under Smart card readers’ device
ACR30 Series Installation Guide Page 15 of 28
Advanced Card Systems Ltd.
Unit 1008, 10th Floor
Hongkong International Trade and Exhibition Centre
1 Trademart Drive
, Kowloon Bay, Hong Kong
Tel: [phone] Fax: [phone]
Website: www.acs.com.hk Email: [e-mail]