User's Manual

3
˙Connect the USB receiver dongle to an available
USB port on your computer. Wait for the computer to go
through its default process of recognizing the new
hardware and installing the built-in native driver. You
don’t need to do anything while your computer is going
through the installation of a new device.
˙Power on the presenter by sliding the on/off switch to
ON position
˙The radio frequency (RF) codes are factory preset for
your convenience; the presenter should be functional at
this point.
˙Pairing: Re-plug the receiver into the USB port of your
computer, then press the connect button on the
Presenter. If the Presenter does not work after 10
seconds, pair them again. (The receiver has auto pairing
function).
On/off Switch
*Power switch on the presenter