2.4GHz Wireless BlueTrace™ Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 Class 1 LED Product CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction Scrolling Wheel & LED Indicator ON/OFF Switch Connect Button Battery Cover Nano Receiver Right button Left button Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. 2’nd 1’st Pull AAA Battery **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse.
Nano Receiver Push Take out Setup the Connection between the Receiver and the Mouse 1. Insert the batteries into the mouse, then follow the steps below. 2. Plug the Nano receiver into the USB port of your computer. 3. If the mouse is not working, please put it into pairing mode. 4. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function).
. The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. 6. When the batteries’ power of the mouse is low, the Low Power indicator will start to blink. *Mouse Indicator LED Indicator LED is on 3 sec. Power ON LED Blinks 3 times During Pairing Low Battery Warning will blink 10 times when turn on.
