2.4GHz Wireless New Triple Wheel BlueTrace™ Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction Front Capacitor Pad (Area A) Left Capacitor Pad (Area B) Right Capacitor Pad (Area C) LED Indicator Triple Wheel Wheel Battery Cover Right button Left button Nano Receiver ON/OFF Switch Connect Button
Triple Wheel By simply touching one of the capacitor pad and scroll the wheel at the same time, the wheel can perform special function. Therefore, with three different capacitor pads it can perform up to three different functions.
Fast scrolling (Front Capacitor Pad) ( Fast scrolling down Lightly touch area A with the tip of your finger then scroll down the wheel with the same finger. (7 times faster than regular scrolling) Fast scrolling up Scroll up the wheel then land the tip of your finger onto area A (9 times faster then a regular scroll) Note: Scrolling down is 7 times rather than 9 times because scrolling down is more ergonomic than scrolling up.
Zoom in and out (Right Capacitor Pad) Zoom in Touch and do not release area C and at the same time scroll up the wheel. Zoom out Touch and do not release area C and at the same time scroll down the wheel. Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. 1’st 2’nd Pull AAA Battery **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse.
Setup the Connection between the Receiver and the Mouse 1. Insert the batteries into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the nano receiver out. 3. Plug the Nano receiver into the USB port of your computer. 4. If the mouse is not working, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again.
LED Indicator *Mouse Indicator LED is on 3 sec. Power ON LED Blinks 3 times During Pairing Low Battery Warning will blink 10 times when turn on.
