Wireless Mouse / MDG USER'S GUIDE Ver.:1.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction DPI switch / LED Indicator Connect Button Right button ON/OFF Switch Backward Tilt Wheel Left button Forward LED Indicator RF Receiver Forward Press this button to view the next page of the Internet browser. Backward Press this button to view the pervious page of the Internet browser. DPI Switch The brightness of LED indicator on the DPI switch indicates the DPI setting in use.
seconds. Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. AA Battery Setup the Connection between the Receiver and the Mouse 1. Plug the RF receiver into the USB port of your computer. 2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pairing mode.
4. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 5.The LED indicator on the receiver flashes when the mouse is moving. 6. When the batteries of the mouse is low, the Low Power indicator will start to blink. 7. Please see the readme for details. LED indicator *Mouse Indicator Red LED is on for 10 sec. Power ON Red LED Blinks for 10 sec.
