User Manual

3
Setup the Connection between the Receiver and the Mouse
1. Plug the RF receiver into the USB port of your computer.
2. Insert the batteries into the mouse, then follow the steps below.
3. If the mouse is not working, please put it into pair mode.
4. Pairing: Re-plug the receiver into the USB port of your computer, then
press the connect buttons on the mouse. If the mouse does not work
after 10 seconds, pair them again. (The receiver has auto pairing
function).
5.The LED indicators on the receiver flashes when the mouse is moving.
6. When the battery of the mouse is low, the Low Power indicator would
blink.
LED Indicator
*Mouse Indicator
Red LED
Blinking
10 sec.
Low Battery Warning
Red LED
O
N 10 sec.
Power ON
Green
LED
Blinking
Pairing (LED OFF when paired or
failed after 10 sec.)