2.4GHz Wireless Optical Mouse USER'S GUIDE Ver.:1.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction Battery Cover Connect Button Scrolling Wheel & LED Indicator Right button LED Indicator ON/OFF Switch Left button RF Receiver Battery and Power Management: Step 1: Pull the battery cover backward. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Insert Pull out For Extra usage hours, use two AA batteries instead of two AAA Batteries.
Setup the Connection between the Receiver and the Mouse 1. Plug the RF receiver into the USB port of your computer. 2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pair mode. 4. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect buttons on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 5.
*Receiver Indicator LED Indicator Green LED ON 3 sec.
