Wireless Mouse USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction ON/OFF Switch Connect Button LED Indicator Scrolling Wheel Backward Right button Forward Battery Cover Left button Nano Receiver Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Pull AA Battery **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse.
Setup the Connection between the Receiver and the Mouse 1. Insert the battery into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the Nano receiver out. 3. Plug the Nano receiver into the USB port on your computer. 4. If the mouse is not work, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again.
*Mouse Indicator LED Indicator LED is on for 10 sec. Power ON LED Blinks for 10 sec. Low Battery Warning LED Blinking During Pairing (LED OFF when paired or failed after 10 sec.
