2.4GHz Wireless Smart Hyper scrolling BlueTrace Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction 1. Left button 2. Right button 3. Scrolling Wheel 4. Forward 5. Backward 6. Hyper Scrolling Switch Key(LED Indicator) 7. Nano Receiver 8. Battery Cover 9. Connect Button 10. ON/OFF Switch Forward Press this button to view the next page in your Internet browser. Backward Press this button to view the previous page in your Internet browser.
Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. 1st 2nd Pull AAA Battery Step 3: Replace the cover. Step 4: Turn on power switch **Warning: *Please insert the batteries with the correct position according to the instruction labeled on the mouse.
Setup the Connection between the Receiver and the Mouse 1. Insert the batteries into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the nano receiver out. 3. Plug the Nano receiver into the USB port on your computer. 4. If the mouse does not work, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again.
7. When low battery, the battery indicator on the mouse will start to blink. LED Indicator *Mouse Indicator LED Blinking During Pairing (LED OFF when paired or failed after 10 sec.) LED Blinks for 10 sec.
