2.4GHz Wireless BlueTrace Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction 8. Battery status LED Indicator 9. Win Key 10. Nano Receiver 11. Battery Cover 12. Connect Button 13. ON/OFF Switch 1. Left button 2. Right button 3. Scrolling Wheel 4. Forward 5. Backward 6. ZOOM Key 7. DPI Switch Key (LED Indicator) DPI Switch The LED indicator under tilt wheel will light up when you plug the mouse into the USB port. The brightness of the indicator indicates the DPI setting in use.
DPI Switch Key (LED Indicator) Win Key Backward Forward Zoom Key Forward Press this button to view the next page in your Internet browser. Backward Press this button to view the previous page in your Internet browser. Zoom Key (Zoom in /out) Press zoom key + scroll to zoom in/ out .
Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the battery as shown inside the battery compartment. Pull AA Battery X 2 Step 3: Replace the cover. Step 4: Turn on power switch **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse. Step 5: If you need to travel with your wireless mouse, made sure you turn off the POWER SWITCH.
Setup the Connection between the Receiver and the Mouse 1. Insert the battery into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the nano receiver out. 3. Plug the Nano receiver into the USB port on your computer. 4. If the mouse does not work, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again.
DPI Switch Key LED Indicator Battery status LED Indicator *LED Indicator LED is on for 3 sec. Power ON LED Blinks for 3 times During Pairing (LED OFF when paired or failed after 10 sec.) LED Blinks for 10 sec. Low Battery Warning DPI Indicated (when DPI switched) Battery status LED Indicator Power ON Wake up 3 LED Bright 2 LED Bright 1 LED Bright LED is on for 5 sec. LED blinks battery status for 5 sec.
