User Manual

CONNECTING YOUR MOUSE
1. If you are currently using a PS/2 mouse, turn off the power to
your computer. (You must Shut down and turn off your
computer before connecting or disconnecting any PS/2 device.
Failure to do so could damage your computer.) This is not
necessary if you are currently using a USB mouse.
2. Disconnect the existing mouse.
3. Connect the receiver to your computer
a. USB: Connect the receiver’s USB plug to the USB Port on
your computer.
b. PS/2: Connect the receiver’s USB plug into the green USB
to PS/2 adapter. Then plug the other end of the green PS/2
adapter into the mouse PS/2 port on your PC.
Æ
4. Place the receiver 8” (20cm) from any other electronic device
such as your computer and monitor.
5. Install the included 2 AA batteries into the battery compartment
located on the bottom of your mouse. Position the batteries
according to the diagram in the battery compartment.
3
Low Batter
y
LED
2 AA Batteries