User's Manual
Table Of Contents
The Screen Cursors Does Not Move Properl
y
Change the angle of your radio receiver,. Try adjusting the receiver and/o
r
mouse to improve reception.
Make sure that the battery low indicator is NOT lit on. Replace batteries if the
low battery indicator is lit on.
You may also need to change the channel / ID for the mouse, Press the
Connect button on the receiver, then press the Connect button on the
mouse.
If your tabletop surface is red in color or is highly reflective like a mirror, you
r
tabletop surface may be interfering with the optical sensor of the mouse,
Try using a mouse pad, or use the mouse on a different tabletop surface.
Mouse not detected
When using the mouse, it may not be detected by the
computer, To remedy this problem, try the following
Make sure the receiver is plugged into the right mouse
port.
Make sure your mouse port has the proper
configuration. Refer to your computer documentation
for the correct port configuration.
You may have other system devices (e.g. a LAN card)
that conflict with your mouse. Check the IRQ/address
settings of these devices for conflicts, and change the
settings as required.
7