User's Manual

4
Note: This RF Mouse is a plug-and-play device. Normally, it’s not
necessary to setup the RF Channel. But if some interference happens,
then you must setup the connection RF Channel.
Setup the connection RF Channel between the
Mouse and the Receiver
1
2
Push the channel reset button on the mouse. Push the channel reset button on the receiver
If the cursor does NOT move after 30 seconds, please-do the steps above.
GREEN LED FLASH (0.5 sec. Regularly)
GREEN LED FLASH (if any action)
GREEN LED ON
Searching the channel
Channel connected
No a c tio n