User's Manual

Targus Wireless Rechargeable Notebook Laser Mouse

3 Insert the supplied batteries, making sure that the

positive (+) and negative (-) ends of each battery match

the polarity indicators inside the battery housing.

WARNING: When replacing the batteries, use only

heavy-duty NiMH rechargeable batteries. Never use

alkaline batteries.

Avoid mixing new and used batteries in a device.

4 Slide the battery cover back into position until it “clicks”

firmly into place.

5 Turn on the mouse by sliding the on/off switch on the

bottom of the mouse to the “on” position.

Note: While the mouse is functioning, no laser light is

visible to the naked eye. Be careful not to look

directly into the emitter hole while the mouse is

active.

Charging the Batteries

For best results, you should charge the mouse at least 4

hours before using it. You can do this via the supplied USB

charge cable. To do this:

1 Connect the cable’s USB connector into an available

USB port on your computer

2 Connect the other end to the mouse.

NOTE: To continuously charge the mouse via the USB

charge cable, your computer must be on and awake.

For best results, turn off your computer’s power

management feature while charging the mouse.